topblog Ivoire blogs

15/08/2019

Yanhua Universal ICP adapter read 8feet chip data without soldering

New!!! YanhuaUniversal Programming Adapter no soldering is required. It features in:

  1. no soldering is required, when using toread the data of 8-feet chip, it works independently and safely.
  2. This clip adapter is compatible with any ofAuto Digital Master III,Digimaster 3ckm100.
  3. The pin comes with smart diagnostic function, the data reading safely and reliably.

 

This is Universal Clip Adapter:

 

 

How to use this Universal Clip Adapter?

 

 

 

  1. Follow the above image to connectD3(or Auto Digital Master) to the Universal Clip Adapter, open the D3 software.

 

  1. Please use the 8feet Puncture Socket or the Universal Adapter to clip the chip well and note the chip pins (the red wire stands for the pin-1).

For your information: this adapter can't be used to test the chip alone, the chip must be inserted into the circuit, the Universal Adapter detect the chip type through the circuit.

 

  1. On the ICP tester, choose the corresponding chip type, click on "Test" to test if the pin is correct or not.

 

 

 

  1. On the Universal Adapter display, you will see the diagnostic successful message. On theD3or Auto Digital Master menu, select the corresponding chip type to read the data, try to reading for more than 2 times, compare if the data is the same, if yes means the data reading succeed.

 

Source:

http://www.obdexpress.co.uk/wholesale/yanhua-icp-tester.h...

06/08/2016

Mercedes Smart Key Teach-in support k-line Smart (1998-2002)

Disclaimer:

Smart Key Teach-in only supports Mercedes-Benz Smart (1998~2002) with K-line protocol.

 

Smart Key Teach-in support ECU type as follows:
Smart-Key-Teach-in-ECU-type-1 Smart-Key-Teach-in-ECU-type-2

MB - Smart vehicles dongle key programmer

SMART Teach-in is required when keys are lost, damaged or if additional key is needed.
Also, this procedure synchronizes engine ECU with BSI - can be used when changing damagedECU or BSI with new/used one!

For adapting each remote with Immobilizer / BSI module the following dongle can be used:
1. Turn ignition ON without starting engine (position "1").
2. Insert dongle in OBD connector (it is located under steering column, near pedals).
3. The LEDs must lit both, then green must blink few times. If all OK, green LED remains lit and red must be off. If  red LED blinks fast, this means an error, you may remove dongle and try again.
4. If red LED is off and green is on, turn OFF the ignition key.
5. Press twice LOCK button on each remote (if 3 button remote used) within 30 sec. Maximum of 4 keys can be programmed.
6. Turn ignition ON again, this completes learning sequence. Remote controls are working only when ignition is OFF, cranking is possible only when vehicle is in UNLOCK-ed state.

http://www.obdexpress.co.uk/

source:http://blog.obdexpress.co.uk/2016/08/05/mercedes-smart-ke...