topblog Ivoire blogs


2016 VAUX-COM & Opcom Firmware 1.64: Confirmed!

Hello bro, i found important information when did search on MH forum. Someone made update Opcom 2016 pro version !!!! share it again here. Hope it helps


Look here..












Cars up to 2016. Corsa E, Mokka, Karl, Adam, etc.

Languages: English and German!!!


Firmware 1.64 and it work just with real pic18f458 OP COM

do not tested with fake pic18f458 (pcb V6.0)

opcom-firmware-16 opcom-firmware-164-real-pc(1)

Good version, working perfect on pcb with Mikrochip processor.

Real year 2016 full version

Tested on cars


Note: all above is shared via

You can go there for more details


Note: In reality, not only Opcom 1.64 but firmware 1.59/1.65/1.70/1.95 comes with the real chip.

Look here: OP-COM with real pic18f458:

Opcom Firmware V1.95

Opcom Firmware V1.65

03:49 Publié dans Blog, car diagnosis tool | Tags : opcom | Lien permanent | Commentaires (0)


(Solved) Nissan Consult 3 Plus reprogramming option was disabled (Gray)

Topic: Nissan Consult 3 Plus reprogramming option was disabled (Gray)


Trouble: I tried to reprogram the ABS module for a 2009 Nissan Murano but reprogramming option was disabled (Gray). any body knows how to activate it? I’m using Nissan Consult 3 plus from the site i confirm this tool can be used for reprogramming, but not know how to


Reply: you need to edit the file DiagnoticTool.ini to enable reprogramming and also IMMO. Or if you have money to waste buy the reprogramming card and the NATS card. Add the following line to the DiagnosticTool.ini file






also make sure system management access_mode is set to 1. That should give you full access. That's not to say that it will work if you do not have the correct calibration file in the reprogramming folder on the C drive.


good luck


Feedback: Thanks it worked


Can I have a chance of having GM GDS2 & Tech2Win on VCM2 units?

Source from some forum:


This might have been answered before. I’ve searched the forum with no luck. Has anyone been able to make this work? Thank you



No it cannot works

Good luck



With Tech2win it will work 40-50% and with Gds 2 it will work 20-30%……..

Because missing Gm protocol (chip) from the Vcm II vs. with Gm Mdi…….

Go and make scan with your Vcm II with Tech2win with one Corsa-d and look with how many Ecu’s it will not communicate!!!!!!!!!1

Then go with one Astra-h then with one Vectra-c and look the same!!!!!!!!!!!





hello !! friends ..

I commented that if it works 100% as I have the 2 teams VCM2 and MDI !!!

works Tech 2 win, SPS, recalibration 100% ….


I just tested it to American ..not sure things in Europe..maybe not works because of Full different protocols

Good luck

It should be not.

Better run GDS2 and Tech2Win with GM MDI interface and use Ford/Mazda IDS with VCM2 unit



Good luck!