topblog Ivoire blogs

27/10/2017

How to Unlock LAUNCH EasyDiag Locked Adapters(With Video)

Hi friends, good news for owners of Locked adapters LAUNCH EasyDiag dug .

 

Note: its not my work. i coped from other

Here you go.

 

Thread: LAUNCH EasyDiag Unlocking Locked Adapters

around on the Internet, collected information and … it turned out!

I will describe the recovery steps for both Locked and Blown

LAUNCH EasyDiag adapters .

We need a

dump of a non-blocked adapter (with 52 firmware on board)The programer
itself

runs the programmer in the J-link

and the program in which I did everything

Programs recommended by Adminom

program for firmware adapter

Unlock-LAUNCH-EasyDiag-Locked-Adapters-1

native application ST-Link

Before we begin, we will

use the utility from Segger to turn our St-Link V2 (clone) into the J-Link programmer

and install the program (downloaded from the link above) with which we will flash our Device * We disassemble the adapter (I took it apart on the board with a knife by cutting the place of the gluing of the case)

Unlock-LAUNCH-EasyDiag-Locked-Adapters-2

connect the programmer to the pictures

Unlock-LAUNCH-EasyDiag-Locked-Adapters-3

J-Link (ST-Link V2 Clone)

Unlock-LAUNCH-EasyDiag-Locked-Adapters-4

launch the J-Flash application

or ST-Link ( also works with St-Link V2, connect it to USB to get power.)

 

Unlock-LAUNCH-EasyDiag-Locked-Adapters-5 Unlock-LAUNCH-EasyDiag-Locked-Adapters-6

Create a new project select the controller STM32F207 IG

Unlock-LAUNCH-EasyDiag-Locked-Adapters-7 Unlock-LAUNCH-EasyDiag-Locked-Adapters-8

after all the procedures connect our adapter to the computer and connect it to the program in the Target tab, select Connect

and well on the video)) ))))

Good luck, the guys write, I will definitely prompt))))

Source:

05:56 Publié dans Blog | Tags : launch easydiag | Lien permanent | Commentaires (0)

Les commentaires sont fermés.